|
|
|
 RiCool-2 Blower [AdvancedTCA] |
|
 PICMG 3.0 compliant
1U rack height
Hot Swappable easy access
Polarity protected
Locked rotor protection
Automatic restart
Programmability
Input fusing
Over temperature alarm
LED red for fail (PICMG 3.0)
LED blue for Hot Swap (PICMG 3.0)
Toggle switch to initiate Hot Swap
Mezzanine control board connections
Thermistor located in outlet air stream
Temperature sensor
Flame sensor
Dual power input
Detects failure in the Intelligent
Peripheral Management Controller IPMC) and/or Management Application (MA). Upon detecting failure, blower immediately goes to full speed.
Sensors (thermistors, hall-effect switches, voltage, etc.) supports all device commands derived by the
Intelligent Peripheral Management Controller (IPMC). Sensor device commands are defined in section 3.0 of PICMG 3.0.
180 cfm (300m3/h)
High static pressure at zero flow of 2.8 - 3.0 inch (71 mm)
H2O; ideal when air filters are used (typical muffin fans
have 0.3 - 0.4 inch H2O)
Service friendly Field Replaceable Unit design
COTS (Commercial Off-the-Shelf)
50,000h at 50° C - 55° C (122° F - 131° F) at
100% speed
55,000h at 50° C - 55° C (122° F - 131° F) at
70% speed |
|
|
|
|
